User guide

USR4204 User Guide
Page 27 of 69
Menu Mode and Batch Mode Command Reference
This section shows an example of each USR4204 menu, describes the functions available in
each menu, and correlates the equivalent Batch Mode command.
Main Menu
At the top of the Main Menu is a banner that displays the current system parameters. Below
the banner are the menu name, the user-programmable device name, and the current login
name (if security is enabled). Next is a list of valid commands, text, and status. Invalid
commands are ignored.
Menu commands listed in this guide are shown within single quotes (');
programmable names are shown within double quotes ("). The corresponding
Batch Mode command is identified following the description of each function.
'A'-'D' Connect to Console
These Connect commands create a full duplex data connection between the USR4204
terminal port and one of its serial ports. The terminal port is fixed at 9600bps, 8N1. The
rate and format of serial ports are programmable to match the console port of the attached
equipment. The current serial port parameters are shown in parentheses next to the port
name.
To close a connection to a serial port, use the Escape Sequence. The Escape Sequence is a
string of identical characters typed rapidly without surrounding characters. The default
Escape Sequence is "---".
T/O Esc Menu Xon Xoff Flow Pass Echo AutoCR DCD Banr
005 - - ^Q ^S OFF OFF ON ON OFF OFF
----------------------------------------------------
MAIN Menu "USR4204 " Logged In: "Admin Username "
CMD
'A' Connect "Console A "( 9600 None )
'B' Connect "Console B "( 9600 None )
'C' Connect "Console C "( 9600 None )
'D' Connect "Console D "( 9600 None )
'1' Toggle "Power 1 "(ON 0.0 Amps)
'2' Toggle "Power 2 "(ON 0.0 Amps)
'Q' Toggle Cellular Mode (OFF)
'W' Arm Ctrl-B for Break
'X' Logout 'P' Change Password
'Y' Config Parameters
'Z' Config Ports
'-' Refresh MAIN Menu