Installation manual

4. 13. SCSI (DVD/CD-RW, Scanner) 21
4. 11. Bluetooth
Bluetooth is attached via the Intel 82801CAM (ICH3-M) USB controllers. This setup is supported by BlueZ ,the
Official Linux Bluetooth Protocol Stack.
As we don’thav e anybluetooth devices, we don’tconfigure Bluetooth.
4. 12. IDE (Disk)
The IDE controller is an Intel 82801CAM (ICH3-M).The hard disk is an IBM Travelstar 60GH AT A -5 with
60.01GB capacity.The controller seems to be similar to the Intel PIIX4 chipset. Everything is nicely supported
by the kernel:
Kernel configuration for IDE disks:
—— ATA/IDE/MFM/RLL Support ——
yes ATA/IDE/MFM/RLL support
—— IDE, ATA and ATAPI Block devices ——
yes Enhanced IDE/MFM/RLL disk/cdrom/tape/floppy support
yes Include IDE/ATA−2 DISK support
yes Use multi−mode by default
yes Generic PCI IDE chipset support
yes Sharing PCI IDE interrupts support
yes Generic PCI bus−master DMA support
yes Use PCI DMA by default when available
yes Intel PIIXn chipsets support
yes PIIXn tuning support
4. 13. SCSI (DVD/CD-RW, Scanner)
The DVD/CD-RWcombi drive isaMatsushita UJDA730 AT API DVD/CD-RW, which we want to use as an
“SCSI-over-IDE” device. Additionally we have an Adaptec APA-1480A CardBus SCSI controller to connect our
scanner.
Kernel configuration for SCSI (DVD/CD-RW, Scanner):
—— ATA/IDE/MFM/RLL Support ——
yes ATA/IDE/MFM/RLL support
—— IDE, ATA and ATAPI Block devices ——
yes Include IDE/ATA−2 DISK support
—— SCSI Support ——
yes SCSI support
mod SCSI CD−ROM support
yes Enable vendori−specific extensions (for SCSI CDROM)
2Maximum number of CDROM devices that can be loaded as modules
mod SCSI generic support
yes Enable extra checks in new queuing code
—— SCSI low−level drivers ——
mod Adaptec AIC7xxx support
253 Maximum number of TCQ commands per device
15000 Initial bus reset in milli−seconds
Note: If we configure for multiple LUN probing, we will end up with 7 CD-ROM devices as the DVD/CD-RW
drive responds to all probed LUNs.
We hav e to inform lilo about our setup by editing /etc/lilo.conf: