User manual

98
Parameters Description
<interface_name>
The switched interface to modify. Limit:
32
characters.
access Sets access type for switched interface. The modem can
allow dial-in only, dial-out only or both (TWO-WAY).
at_command String representing any generic AT command. When
implemented, output is displayed immediately on CLI.
connection_type Sets connection type for switched interface. Options:
• Direct_net
uses the protocol parameter’s setting
to create a virtual node connection. Other
connection types establish a virtual terminal
connection, with the type determined by
login_service parameter. Direct_net does not
support the SLIP protocol.
• Direct_conn
- User name and password are
supplied by parameters in this command.
• Normal
- prompt for both user name and pass.
• Prompt_user_only
- only prompt for user
name.
• No_prompt
- only prompt for password
dial_prefix Prefix added to all the phone numbers dialing from this
port. Limit of 7 characters.
host_type Identifies how connection is established. Dial-in user is:
• prompt
- prompted to enter a host name or add.
• select
- connected to a login host, selected from
the list of login hosts, determined by the
host_select field in the set connection command.
• specified
- connected to the configured IP add.
host_address IP address to connect a dial-in user to, if the host type is
specified, and connection_type is direct_conn or
direct_net.
init_script Name of modem initialization script used. Maximum
size: 7. If you are setting an init_script for a Modem
Pool or Interface the init_script name must already
exist. A null string (“”) indicates the name will be
deleted.
login_service Login service to use if the connection_type is not
direct_net. Options:
• TELNET
• RLOGIN
• ClearTCP
message String to display to a dial-in user when connection is
set. Limit:
32
characters.
prompt
String to present the dial-in user. Limit:
64
characters.