User manual

94
Parameters Description
<group_name> Designation of the modem group. Limit of 32 characters.
access Sets access type for switched interface. Modem can
allow dial-in only, dial-out only or both (TWO-WAY).
connection_type Sets the connection type for switched interface. Options:
• Direct_net
uses the protocol parameter’s setting
to create a virtual node connection. Other
connection types establish a virtual terminal
connection, with the type determined by
login_service parameter. Direct_net does not
support the SLIP protocol.
• Direct_conn
- User name and password are
supplied by parameters in this command.
• Normal
- prompt for user name
and
password.
• Prompt
_user_only - prompt for user_name only.
• No_prompt
- prompt for password only.
dial_prefix Prefix added to all phone numbers dialing from this port.
Limit of 64 characters.
host_type Identifies how dial in connection is set up. Options:
• prompt
- prompted to enter host name or add.
• select
- a host is chosen from a login host list you
specify, configured by
set connection
command.
• specified
- connected to IP add. configured here.
host_address IP address to connect a dial-in user to, if the host type is
specified, and connection type is direct_conn or
direct_net.
init_script
Modem initialization string to use. Limit:
7
characters.
login_service The login service to use, if the connection type is not
direct_net. Options:
• TELNET
• RLOGIN
• ClearTCP
message String displayed to dial-in user when connection
established. Limit:
64
characters.
password Parameter used if the connection type is no_prompt or
prompt_user_only.
prompt
String to present the dial-in user. Limit:
64
characters.
protocol Protocol to connect with, if the connection type is
direct_net. SLIP is not supported by direct_net
connection type.
TCP_port TCP_PORT number for the login host. Parameter used
when connection type is
direct_conn
or
direct_net
.