User manual

CLI Reference Guide 93
set modem_group <
group_name
>
access [
DIAL_IN | DIAL_OUT | TWOWAY
]
connection_type [
DIRECT_CONN | NORMAL |
DIRECT_NET | NO_PROMPT |
PROMPT_USER_ONLY
]
dial_prefix [
string
]
host_type [
PROMPT | SELECT | SPECIFIED
]
host_address [
IP_address
]
init_script [
name
]
login_service [
TELNET | RLOGIN | CLEARTCP
]
message [
“login_message”
]
password [
string
]
prompt [
“prompt_message”
]
protocol [
ARAP | PPP | SLIP
]
TCP_port [
port_number
]
type [
NETWORK | LOGIN | LOGIN_NETWORK
]
user_name [
user name
]
Configures a previously defined modem group. All the interfaces in the
specified modem group are configured with this one command. Note that all
the parameters that can be set using
set switched interface
can also be set using
this command, but this command sets multiple interfaces with one command.
Note
: When setting connection type, be aware that the
direct_net
parameter
does
not
support the
SLIP
protocol. Direct_net requires the use of a negotiated
protocol, which SLIP is not.
See table on next page.