User manual

64
list ip interface_block
Displays the IP addresses associated with each system interface. If the
interface has a point-to-point connection, then the neighbor field contains the
address of the remote system. This command lists:
• Address
- IP address of the NETServer interface
• Neighbor
- IP address of the remote system
• Status
- status of the connection: ENABLED or DISABLED
• Interface
-
eth:1
list ip networks
Displays all the IP networks you previously defined using the
add ip network
command, including any dynamic networks created with a modem established
a PPP connection to the NETServer. It also lists:
• Name
- network designation
• Prot
- always the IP protocol
• Int
- name of the interface this network runs on
• State
- state of the network; ENABLED or DISABLED
• Type
- STATIC or DYNAMIC network
• Network Address
- address of the IP network
list ip routes
Displays all the statically defined IP routes that you previously defined using
the
add ip route command,
including any routes learned via RIP. It lists:
• Destination
- IP address that the route resolves to
• Prot
- LOCAL, RIP or NetMgr
• NextHop
- address of the gateway used to reach this route
• Metric
- number of router hops away this route is from the system
• Interface
- interface that the route uses