User manual

list appletalk routes

Displays the entries in the AppleTalk Routing Table. The table lists:

• Address Range

- Range of addresses used on this route

• Next Hop

- AppleTalk address of the next hop router. 0.0 implies the

entry is a local network

• Port

- Address of the network (route destination)

• Hops

- How many hops away this network is

• Type

- AppleTalk, PPP, Serial-Non Standard or Other

• State

- State of the path to this network, listed from best to worst:

GOOD, SUSPECT, PRETTY BAD, BAD. The state of this network

worsens, when networking packets from that network fail to arrive. The

more packets are missing, the worse the state is revealed.

list appletalk zones

Displays all the AppleTalk zones configured for the entire system.

• Name

- zone name that you learned via routing (defined by

add appletalk

zone

command

)

• Addr Range

- range of addresses used in this zone

• State

- state of the zone

• Port

- interface the zone runs over

• From

- address of router from which the zone and network was learned

list available servers

Displays the available network servers. For example: TELNET service, TFTP

service, or ClearTCP. The services listed by this command are used in the

server_type

field of the

add network service

command.