User manual

56
enable telnet escape
If the TELNET escape character was disabled by the
disable TELNET escape
command, this command re-enables it. When enabled, TELNET client users
who press the TELNET escape key during their session will get a TELNET
command line.
By default the escape character is
]
(cntrl ] ). A TELNET user can change
it using
set escape
in the TELNET program.
enable user <
user name
>
Allows a user to establish dial in and/or dial out sessions. You must have
previously added the user using the
add user
command, where
enabled
is the
default. You can use
list users
to see which users are currently disabled.
EXIT
exit
Leave the CLI, but keep this connection open. This command returns you to
the Dial-In User or TELNET commands.
HANGUP
hangup interface <
interface_name
>
Disconnects any calls (causes the connection on the specified interface to
hangup and leave the interface(s) in an ENABLED state. You can enter
multiple interfaces (ssss,ssss,ssss ...) or a range (mod:1 - 9).
hangup modem_group <
name
>
Makes the modem group unavailable for dial-in users. This command has the
same effect as hanging up the phone.