User manual

CLI Reference Guide 53
enable interface <
interface_name
>
Enables the specified interface. Enabling an interface enables it to transmit
and receive data. You can enter multiple interfaces (ssss,ssss,ssss ...) or a
range (mod:1 - 9). You can use
list interfaces
to see which interfaces are
defined, and whether they are currently disabled.
enable ip icmp_logging
Enaables
display
of the Internet Control Message Protocol to the syslog server.
enable ip forwarding
Allows all IP networks to forward (route) packets. You should only need to
use this command if you previously used
disable ip forwarding.
enable ip icmp_logging
Enables the Internet Control Message Protocol . It provide feedback about
routing, diagnostic or error messages encountered by IP. Use
show icmp
counters, show icmp counters
commands for detailed information.
enable ip network <
network_name
>
Enables the specified IP network, which you previously defined using
add ip
network
. You can use
list ip networks
to see the currently defined IP
networks, as well as their current status.
enable ip rip
Enables the RIP protocol for all IP networks. RIP protocol is set to NONE by
default. You can check the RIP version using
show ip network settings
, and
modify it using
set ip network.