User manual

48
disable authentication remote
Disables user authentication using remote RADIUS servers. You must have
set
authentication
to define the RADIUS server, and enabled it using
enable
authentication remote
. You can use
show authentication
to see if remote
and/or local authentication is currently enabled. Users can still be
authenticated using local authentication, if you have enabled it.
disable interface <
interface name
>
Disconnects any calls from the specified interface and leaves the interface in a
disabled
state. A disabled interface remains in the Interface Table, but will not
transmit or receive any data. You can enter multiple interfaces (ssss,ssss,ssss
...) or a range (mod:1 - 9). Use
list interfaces
to see the currently defined
interfaces, and their status.
disable ip icmp_logging
Disables
display
of the Internet Control Message Protocol to the syslog server.
disable ip forwarding
Causes the system to stop forwarding any packets over IP networks. You may
want to
disable ip forwarding
if you are using the system only as a terminal
server. Users who TELNET to the system can still connect to remote hosts.
disable ip network <
network_name
>
Disables the specified IP network. Make sure there is no activity on this
network before disabling it.
disable ip rip
Disables the RIP routing algorithm on all IP networks. You can use
show ip
routing
to see the current status of IP routing. This saves system space by
preventing a large RIP database, which is useful for networks connecting over
the WAN interface.