User manual

140
show TCP settings
Displays system-wide TCP settings. Note: These settings cannot be edited.
TCP SETTINGS
• Retransmission Algorithm
- for example, Van Jacobson
• Minimum Timeout
- minimum retransmission timeout interval
• Maximum Timeout
- maximum retransmission timeout interval
• Maximum Connections
- sum of TCP connections allowed. Default:
1024
.
show telnet
or
show telnet settings
Displays the status of the TELNET
escape
feature (ENABLED or
DISABLED). It is set using
disable
and
enable TELNET escape
commands.
show udp
or
show udp counters
Displays statistics for UDP datagrams.
INPUT COUNTERS
• Total Input Datagrams
- sum of UDP datagrams received
• Input but No Port
- sum of received UDP datagrams for which there was
no application at the destination port
• Input with other Errors
- sum of received UDP datagrams that could not
be delivered for reasons other than the lack of an application at the
destination port
OUTPUT COUNTERS
• Total Output Datagrams
- sum of UDP datagrams sent
show user <
name
>
or
show user
<name
> settings
Displays the parameters defined for the specified user. The type of information
displayed depends on the type of user you specify. You can use
list users
to
see which users are defined, and what
type(s)
user each is.