User manual

CLI Reference Guide 107
Parameters Description
<user name> User, who must have network as the type.
address_selection Determines how the IP address will be assigned for
incoming (client) IP network connections.
• NEGOTIATE
- brokers IP address between
remote client and local user.
• ASSIGN
- chooses address from IP pool,
configured using set ip system.
Default
.
• SPECIFIED
- uses IP address set in
remote_IP_address value
appletalk Sets interface for user to allow AppleTalk across this
link.
default_route_
option
Automatically sets the IP address of a remote default
router by
negotiation
. This parameter takes
precedence over a default route (gateway) set by
add
framed_route user
or
add ip defaultroute
commands,
which require
manual
IP address entry.
filter_zones Enables filtering for Appletalk zones.
header_compression Sets TCPIP compression or no header compression.
ip Sets interface to enable/disable prot. Default: enable.
ip_routing Sets routing type (RIP packets) accepted on this
connection.
• LISTEN
- detects packets destined for
system’s nets
• SEND
- routes packets destined for the
remote network
• BOTH
- both listens and sends
• NONE
- ignores all routing packets.
Default
.
ipx Sets interface for this user to enable/disable IPX prot.
ipx_address For an IPX connection, address of remote network.
ipx_routing Sets type of IPX RIP and SAP packets to accept on
this connection.
• LISTEN
- detects RIP/SAP packets headed
for system’s networks
• SEND
- routes pckts. destined for remote net
• RESPOND
- if requested, answers with IPX
RIP or SAP data.
Default
.
• ALL
- detects, sends, answers with RIP/SAP
packets
• NONE
- ignores all routing packets