User manual

Network Dial In Access 5-1

Step 2 - Specify a Remote Address

If you want to explicitly specify the network user's remote IPX

address, follow the instructions in this step. If you want the

remote IP address to be selected from a pool or negotiated,

go to step 3.

Use the following command:

set network user

<name>

ipx_address

<ipx_address>

For example:

set network user glenn ipx_address 100

Note: If the IPX address specified in a user's profile is in use

when the user dials in, the call will be dropped.

Step 3 - Set the Address Selection Method

When you create a network user, the default IPX address is set

to 00000000.

• If the remote computer has an IPX address configured on it,

and an IPX address is not specified in the user profile, the

NETServer will negotiate the remote address.

• If the NETServer cannot negotiate an IPX address an IPX

address will be selected from the pool, which is set globally

using the set ipx system command (see Configuring an IPX

Address Pool on page 5-6).