User manual

Network Dial In Access 5-11
Step 3 - Set the Address Selection Method
If the network user's address is not specified, you need to define
whether the user's remote IP address is assigned or negotiated:
set network user
<name>
address_selection
[assign | negotiate | specified]
assign Configure an IP address from the IP address
pool, which is set globally using the
set ip system command (see Configuring an IP
Address Pool on page 5-6)
negotiate PPP connections only. The remote computer
must have an IP address configured. The
NETServer tries to learn the remote
computer’s IP address using IPCP address
negotiation. If the remote computer does not
have an address configured, the user is
disconnected
For example:
set network user kay address_selection negotiate
Step 4 - Save Your Work
Use the following command:
save all
Continue with one of the following sections of this chapter for
more information on setting other network user parameters:
• Configuring PPP Parameters
• Configuring Additional Parameters