User manual

5-10 Network Dial In Acces

Tip: At this point, it may be helpful to use the show user

command to display the user's default parameters. This allows

you to decide which parameters you need to set, and which

parameters you can leave as defaults.

For example, to add a network user employing PPP over IP,

type:

add user kay password howe type network network_service ppp

Step 2 - Specify a Remote Address

If you want to explicitly specify the network user's remote IP

address, follow the instructions in this step. If you want the

remote IP address to be selected from a pool or negotiated, go to

step 3.

Use the following command:

set network user

<name>

address_selection specified

remote_ip_address

<ip_address>

If you define the address selection method as specified, you

must also specify the remote IP address in the same command.

For example (abbr.):

set net user kay add spec rem 195.114.123.16