User manual

IP Terminal Server Setup 4-
9
IP Terminal Service Case Study
This section provides an example how to configure a login user
to dial-in to the NETServer and establish a Telnet session with a
host machine on the network. The user will be prompted for the
login service and host address.
Figure 2 below depicts the remote terminal connection for a user
named Jack to the corporate LAN. Jack's home computer uses
VT100 terminal emulation software to establish a IP terminal
session with any host on the LAN that he is authorized to
access. In this example, Jack will use Telnet to access a host
named "quartz".
NETServer
PSTN
Jack's
Computer
Login Host
Granite
195.112.133.10
Telnet
Login Host
Quartz
195.112.133.2
VT100 Terminal
Emulation
(8 bits, no parity, 1 stop bit)
Telnet
Figure 2. IP Terminal Service Example
Note: Many of the commands and keywords shown in this case
study are abbreviated. For detailed information about
command syntax, refer to the CLI Reference Guide.