User manual

IP Terminal Server Setup 4-

Configuring Login Users

Remote login users can use login services such as Telnet, Rlogin,

or ClearTCP by dialing into the NETServer. Login users can

connect directly, or be configured as callback users, meaning the

NETServer will call the user back at a phone number specified

in their user profile.

You can configure the user to use a specific login service and

access a specific login host, or you can configure the user to

determine the login service and login host.

Note: You can also specify login user information in RADIUS.

When RADIUS authenticates a user, it can also pass on user

configuration information to the NETServer. For more

information, refer to Appendix E, RADIUS Authentication

and Accounting.

To configure a login user:

Step 1 - Add the User

Use the following command:

add user

<name>

password

login_service

[rlogin | telnet | cleartcp]

type

[login | lnetwork | callback]

Password

Unique user password.

Specifies the default login service. The default is Telnet. This

parameter can be one of the following:

Telnet Supported by most TCP/IP computers,

Telnet lets the user log in to hosts that

support it.