User manual

3-4 Configuration Overvie

Facilities Table

You can check the this table to judge system performance. The

Facilities Table contains each NETServer event facility and its

associated log level. Each facility generates unique event

messages during processing which can be sent to a syslog server

you define.

Facilities are configurable in that you can change log levels from

the defaults shown below. Available log levels are: debug,

verbose, common, unusual and critical, with critical being the most

severe event. For more, refer to Appendix D, Event Messages.

Hosts Table

This table contains a list of local hosts. The table is used to

translate names to IP addresses and vice versa. This allows

users and administrators to type host names rather than

addresses.

The Hosts Table is especially useful if your network does not

have a name service such as DNS. If your network has a name

server, the NETServer first tries to match the host name with an

IP address using the Hosts Table before using the name server.

Note that IPX networks do not use this table since SAP

automatically provides the functionality of a name service.

Initialization Script Configuration Table

This table contains serial interface initialization scripts sent to a

modem each time the port is reset (a modem resets itself every

time it disconnects).

Initialization scripts for modems will probably contain the AT

commands needed to configure them for use on your network.

Module Table

This table contain information used by processes or management

features that run in the background. Display a list of these items

using the list processes command.