User manual

2-38 Basic Installation and Setup

Note: To verify network settings, use list networks command.

Save your work by typing:

save all

AppleTalk Configuration

Important: Even if your network uses only the AppleTalk

protocol, you must still set up an IP address for the NETServer

if you want to use our NMP program or SNMP later.

To configure the NETServer's LAN interface for an AppleTalk

network:

Specify network information.

The address range is the range of nodes from start to end

address, expressed as <sss-eee>. The start address:

• Can only be 0 if the end address is 0

• Can be 1-65280, as can the end address

• Must be less than or equal to the end address

Use the following command:

add appletalk network

address_range

interface

<eth:1>

For example (abbr.):

add apple network pixie address_range 1-5 interface eth:1

Provide zone information. Be aware that the first zone

specified is the default zone. Use the following command:

add appletalk zone

<zone_name,zone_name …>

network

<name>

For example:

add appletalk zone west,east,south network pixie