User manual

Basic Installation and Setup 2-3

A display similar to the one shown below appears:

LAN A Configuration Information:

Network Address: [0788] [002608C0D53F4z]

Hardware Type: [3Com 3C505 EtherLink Plus (Assy 2012 only)

V2.30EC (880813)]

Hardware Setting: IRQ=5, IO=300h, DMA 5

The above example only has one frame type, so the network

address is 0788.

Jot down the network address for a frame type you’ll use.

Setting IPX Parameters

To configure the NETServer's LAN interface for an IPX network:

Specify IPX network information including the network

name, address, interface and frame type of the network

segment connected to NETServer’s LAN port.

Note that the same physical network segment will have a

different network number for each frame type used. Be sure

to enter the network number associated with the chosen

frame type. Use the following command:

add ipx network

address

[ipx address]

interface

[eth:1]

frame

[ethernet_ii | snap | dsap | novell_8023]

For example (abbr.):

add ipx net segment2 add 00000576 int eth:1 fra ethernet_ ii

Note: You can omit preceding zeros - NETServer will accept

“576” as the correct IPX network number.

Set the IPX default gateway with the format

xxxxxxxx.xx:xx:xx:xx:xx:xx where xxxxxxxx is the IPX

network address and xx:xx:xx:xx:xx:xx is a MAC address.

set ipx default_gateway

For example:

set ipx system default_gateway 11.11.01.11.00.11