User manual

2-36 Basic Installation and Setup
A display similar to the one shown below appears:
File server name: USR_SERVER_ONE
IPX internal network number: 0000000A
Western Digital Star EtherCard PLUS Driver v2.05 (910424)
Hardware setting: I/O Port 300h to 31Fh, Memory CC000h to Cffffh,
Interrupt Ah
Node address: 0000C0488D28
Frame type: ETHERNET_802.3
Board name: TENBASE_802.3
LAN protocol: IPX network 00000255
Western Digital Star EtherCard PLUS Driver v2.05 (910424)
Hardware setting: I/O Port 300h to 31Fh, Memory CC000h to Cffffh,
Interrupt Ah
Node address: 0000C0488D28
Frame type: ETHERNET_802.2
Board name: TENBASE_802.2
LAN protocol: RPL
LAN protocol: IPX network 00000684
This is an example of the information returned for one
version 3.xx card that has two different frame types. The
card has one port address, but two LAN protocol network
addresses, one for each frame type. The network number
for 802.3 is 00000255, and for 802.2 it is 00000684.
4.
Write down the LAN protocol IPX network number for the
frame type you want to use.
For File Servers Running Novell Version 2.xx
1.
Go to the console of a file server that is on the same network
segment as the NETServer.
2.
Press CTRL-ESC until the : (colon) prompt appears.
3.
Type the following:
config