User manual

Basic Installation and Setup 2-3
5
IPX Configuration
To configure the NETServer's LAN interface on an IPX network,
you must:
• Determine the IPX network number
• Set the NETServer IPX parameters
Important: Even if your network uses only the IPX protocol, you
must still set up an IP address for the NETServer if you want to
use our NMP software or SNMP application later.
Determining the IPX Network Number
If your network uses the IPX protocol, you must first enter the
IPX network number of the segment connected to the
NETServer's LAN port. You can find this network number
using the Novell CONFIG utility.
For File Servers Running Novell Version 3.xx
1.
Go to the console of a file server that is on the same network
segment as the NETServer.
2.
From the Novell Console program press CTRL-ESC, then
ESC, until the : (colon) prompt appears. Select System
Console and press the key.
3.
Type the following:
config