User manual

2-34 Basic Installation and Setup

below but you must also specify the order you prefer they

be employed. This value is the preference number. Type:

add dns server preference

<number

> address

For example:

add dns server preference 1 address 192.75.222.182

Note: The DNS server is only consulted to resolve host names

not found in the hosts table. If you are using a name service, the

hosts table may be left empty. Also, you may use the resolve

name command to learn DNS host names or numbers. See

Chapter 9: Administrative Tools for more information.

Specify your default domain - the Ethernet segment where

your system resides and where you are defaulted to should

you forget to name the DNS server. Adding this entry to the

Hosts Table avoids you having to always specify the

domain. Use the following command:

set dns domain_name

For example:

set dns domain_name usr.com

Save your work by entering the following command:

save all

If your network does not use the IPX protocol, you may now go

to Configuring a Manage User; otherwise complete the steps in the

IPX Configuration section.