User manual

Basic Installation and Setup 2-31

Optional. If you plan to use an SNMP application to

configure and manage the NETServer, you must specify

SNMP community values.

SNMP community names segregate administrative

management groups and should match the community

settings of your generic SNMP software.

You must set the following SNMP community values:

• name - community name

• address - IP address of the Windows SNMP manager

• access - either read-only or read-write access

Note: To retain a public community with read-only

privileges, assign the address to any station (0.0.0.0.).

To add the SNMP community values, use this command:

add snmp community

<name>

address

access

[RO | RW]

For example:

add snmp com mis add 192.77.202.30 acc rw

Note: Command keywords can be abbreviated, as long as

they are unique to the command.

Save your work. This command saves to flash memory.

save all

Manually Configuring the LAN Interface

This section describes how to manually configure the

NETServer's LAN interface (eth:1) for IP, IPX or AppleTalk

networks.