User manual

2-30 Basic Installation and Setup
To begin manual configuration:
1.
Power on the NETServer. The "NETServer>" prompt
appears. When you’re prompted by the Quick Setup
Program to continue, type: no
2.
Name your NETServer and specify additional system
information. The name you enter serves as the NETServer's
DNS name and SNMP system name. The name will also be
the name that the NETServer advertises in SAP broadcasts.
The name must be unique - no other device on your
network can share it. You should also indicate the following
information:
• location - where the NETServer actually resides
• contact - the person to contact about NETServer issues
Use the following command:
set system name
<“NETServer name” (up to 64 characters)>
location
[“system site”]
contact
[“contact information”]
You can enter the command all at once or in separate
commands. For example:
set system name “total control” location "boston" contact
“Keyser Sosay @ 508 123-4567 666x”
Or you can type:
set system name “total control”
set system location "boston"
set system contact " Keyser Sosay @ 508 123-4567 666x”
3.
Optional. Set the system date and time using this command:
set date
<dd-mon-yyyy>
time
<hh:mm:ss>
For example:
set date 01-jan-2001 time 01:01:01
Note: If you plan to use our Windows-based NMP application to
manage your NETServer, continue. If not, skip to step 4.