User manual

Basic Installation and Setup 2-2

You need to specify the framing for the IPX network. It should be

one of the following: "ethernet_ii", "snap", "dsap", "novell_8023."

>>> What is the framing for the IPX network [ethernet_ii]? ___

You can either assign each user his or her own address or you

can set aside a pool of addresses for dynamic allocation.

>>>Do you want to set up an address pool [yes]? __

The address pool is a continuous range of addresses.

>>>What is the initial address in the pool []? _______

>>>How many addresses should be the pool [16]?_______

Quick Setup AppleTalk information

The network name is the name by which the AppleTalk network

will be identified and configured in the future.

>>> Enter the name of your AppleTalk network [appletalk] :

____________

All AppleTalk addresses should be between 0 and 65280.

>>> Enter the start of the network range [ ] : _____

The end address must be greater than or equal to the start

address. If the start address is zero, the end address must also

be zero.

>>> Enter the end of the network address [ ] : _____

>>> Enter the default zone name [ ] : ____________

>>> Would you like to enter more zone names [no]? : ___

You need to specify the default AppleTalk network range of the

router on the other "side" the WAN. This must be the same as

configured for the other router.

>>> Enter the start of the network range of the other router [ ] :

_____