User manual

2-20 Basic Installation and Setup
your communications software for 8 data bits, no parity and
1 stop bit.
4
Examine the back panel of the NETServer. Find the lower
bank of dip switches (next to the NETServer Configuration
description) . Set DIP Switches 1 and 2 to a baud speed
setting of your choice. See Figure 9 below for options.
1
2
1
2
1
2
1
2
9600 bps 19800 bps 38400 bps 57600 bps
Figure 9. DIP Switch baud rate settings
Note: It isn’t necessary to change any V34 modem and I-modem
(upper bank) DIP Switch settings at this time.
Using the CLI
Quick Setup
Program
You’re now ready to begin configuration.
If you want to use the CLI to configure your NETServer Plus,
we recommend you use the Quick Setup program on the CLI to
get the unit up and running fast. This program incorporates a
Wizard to help you step by step through the process. A script of
the Quick Setup follows: use it to jot down information you’ll be
prompted for.
Note: If you don’t want to use Quick Setup, skip to the next
section for manual configuration.
Power on the NETServer. The following prompt will appear:
NETServer>Welcome to the NETServer Quick Setup
The NETServer Quick Setup will let you set up simple
configuration for your whole system or different portions of the
system.