User manual

2-18 Basic Installation and Setup
Cabling
Examine the NETServer Plus V.34 back panel illustration
below for cable installation. The I-modem back panel offers
similar functionality but I-modem, network and console
ports may be arrayed differently. See Figure 7 below.
Figure 7. Cable connections
1
Be sure the NETServer is turned off. Plug one end of the
power cable into the power connector on the NETServer
and the other end into a grounded AC outlet or power strip.
2
Attach the type of cable that is appropriate for your
network. There are Coaxial, UTP or Auxiliary network
connectors on the Ethernet rear panel, allowing attachment
via Thinnet (10Base-2) or Twisted Pair (10 Base-T). The
NETServer automatically detects which type of network
cabling you’re using.
3
Attach a phone cable (supplied) to each of the modem jacks
you want to use.