User manual

2-16 Basic Installation and Setup
Note: For desktop and rack mounting:
* DO NOT block the fan on the right side of the unit.
* Keep the unit in a dry place at room temperature.
* Keep the unit face up and level - don’t stand it on its side.
Installing on the Desktop
Carefully remove the NETServer Plus from the box and attach
the four rubber feet (supplied) to the recesses in the bottom of
the unit. The bottom panels of V.34 and I-modem units are
similar. See Figure 4 below.
Figure 4. Bottom panel foot recesses
Installing on the Rack
1
Use the provided screws to fasten the two flanges to the
sides of the NETServer. See Figure 5 below.
Flange
Back Panel
Figure 5. Rack flanges