User manual

Basic Installation and Setup 2-1

Using add and set commands

You can use the add and set commands to set and change

system parameters. These matched commands are functionally

related, but also differ dramatically. Table entries such as user,

interface, network, etc., require that you use the add command

to set the initial parameters. You can then use the set command

to change parameters that have been added.

Using list and show commands

You can use the list and show commands to view table entries

or detailed table entries. The list command displays a list of

table entries only, while the show command displays

information about a single line in a table or a set of scalars (non-

table items).

Reset I-modem Interfaces

If you make changes to any I-modem port, you must reset the

port before the changes can take effect. This will close any

active connections.

For example:

set imod interface mod:1 call_type internet at_command ATZ!

Rebooting

The only change that requires you to reboot the NETServer is to

change its LAN port (eth:1) configuration. If you change the

configuration, you must save your work using the save all

command and type either reboot or shutdown.

Hardware Installation

You’re now ready to install the hardware.

If you want your NETServer Plus to sit on the desktop, continue

with the next section. If you plan to rack mount the unit, skip to

Installing on the Rack.

You’ll notice that the following illustrations are of V34 units. I-

modem features may be arrayed differently but their

functionality is similar.