User manual

2-6 Basic Installation and Setup
The NETServer routing engine is a completely separate device
from any of the I-modems. Its job is to route data from its ports (all
B-channels of all internal I-modems) to its LAN (Ethernet)
interface and vice versa. However, it is also able to configure and
use the internal I-modems to establish connections with remote
devices. See Figure 3 below.
Figure 3. Conceptual view of the NETServer/8 I-modem
Ordering ISDN Service
Although efforts are being made to simplify ISDN ordering, it
can still be a complex process. This section should give you and
your local telephone company all the information you need to
set up your ISDN lines correctly. Here’s what to do:
1
Call your local telephone company to request your ISDN
lines. Explain NETServer 8/16 Plus requirements as
described in this section.
2
Your local telephone company will give you information
about your lines and settings.
3
Program the line’s settings into your NETServer’s internal I-
modems.
If, after looking over this chapter, you decide you would
like assistance with the ordering process, call the U. S.
Robotics I-Team at [phone].