User manual

E-12 RADIUS Authentication and Accountin

The syntax for specifying the for incoming and/or outgoing

packets is:

Filter_ID=

input filter filename / output filter filename

For example, if you want to specify a filter that is applied to

incoming packets only (input filter):

Filter_ID=pktfilter.fil

To specify a filter that is applied outbound packets only (output

filter), place a slash (/) before the output filter filename. For

example:

Filter_ID=/my_filter.fil

To specify an input and output filter in the same entry, enter

both filter filenames separated by a slash. For example:

Filter_ID=pktfliter.fil/my_filter.fil

Use the following command to set this parameter locally:

set user <name> input_filter <filter_name>

set user <name> output_filter <filter_name>

Framed-Compression

Specifies whether to use TCP/IP (Van Jacobsen) for the link.

More than one compression protocol can be sent. The

NETServer is responsible for applying the proper compression

protocol to appropriate link traffic.

Use the following command to set this parameter locally:

set network user <name> header_compression [none | tcpip]

This is the name or IP address of the host to which a login user

will log on and connect.

Values IP address

Default 0.0.0.0