User manual

RADIUS Authentication and Accounting E-11
Note: If you do not enter a mask value following the IP
address, the NETServer automatically sets the netmask to
255.255.255.255.
Framed-Routing
Determines whether the NETServer permits Routing
Information Protocol (RIP) packets to be sent to or from the
remote user.
Note: This parameter only applies to IP RIP v1 in RADIUS. The
NETServer software supports both IP RIP v1 and IP RIP v2.
Values Listen - The NETServer listens for incoming RIP
packets
Broadcast - The NETServer broadcasts RIP packets
to the remote user
Broadcast-Listen - The NETServer broadcasts RIP
messages to the remote user and listens for
incoming RIP packets
None - The NETServer does not send any RIP
packets to the remote user and discards any RIP
messages from the user
Default None
Use the following command to set this parameter locally:
set network user
<name>
ip_routing
[both | listen | none | send]
Filter-Id
Identifies the packet filter that controls the user’s access to the
host by specifying a filter file stored in the NETServer flash file
system.
Values ASCII string (maximum 253 characters)
Default NULL