User manual

E-10 RADIUS Authentication and Accountin

Use the following command to set this parameter locally:

set network user <name> network_service [ARAP | PPP | SLIP]

Framed-IP-Address

Specifies the IP address that is assigned to the user for the

duration of the connection.

If the NETServer is configured to use Assigned Addresses, this

field is not applicable.

The NETServer will assign the user a temporary IP address from

the Assigned Address pool for the duration of the connection.

Values IP address

Default 0.0.0.0

The address 255.255.255.255 causes the user to be prompted for

an address, while the addresses 0.0.0.0 and 255.255.255.254 will

cause the server to pick an IP address from the IP address pool.

Use the following command to determine whether a user's client

IP address is negotiated, assigned from the configured IP pool, or

specified by the user:

set network user <name> address_selection

[assign | negotiate | specified]

Note: If you set the user's address selection to specified, you

must also enter the IP address.

Framed-IP-Netmask

Specifies the user's remote IP address netmask. When the

destination is a host, the value must be 255.255.255.255.

Values Netmask

Default 255.255.255.255

Use the following command to set the user's netmask locally:

set network user <name> remote_ip_address <ip_add>/<mask>