User manual

Event Messages D-
9
If the IPX network address for the WAN link is
configured based on the IPX address, modify the
address pool to exclude that specific IPX address
"Failed to fetch user info %d, status = %d/n"
Meaning: The IPX process tried to get user-specific
information but failed
Action: The user may be disabled. Check the state of the
user using the show user command.
"Call initiate failed for an unknown user %x/n"
Meaning: The IPX process tried to make a dial-out
connection for an on-demand user.
Action: Check the critical messages for the Call Initiation
facility for information about the failure.
Call Initiation Process Messages
"CIP: Unable to find an available default host for user %s, %x/n"
Meaning: The user tried to connect to a host from the login
host table, but there is no available host
Action: The login host table is probably empty. Add a
host to the table and let the user dial in again
"CIP: No available modem is found for modem group, %s/n"
Meaning: There is no available modem in the modem group
Action: If there is no modem available, the user should
wait until one becomes available. If the modem
group contains a subset of the available modems,
you can add modem interfaces to this modem
group
"CIP: The port is disabled for login services, %x/n"
Meaning: The user is a login user, but the interface is
configured for network users
Action: Set the port_type to login_network or login