User manual

LEDs and DIP Switches C-9
NETServer CONFIGURATION DIP Switches
The NETServer CONFIGURATION DIP Switches control the
NETServer hardware. See Figure 5 below.
1
2
3
4
56
ON
OFF
78
9
10
Figure 5. NETServer CONFIGURATION DIP Switches (factory defaults)
Switch Function
1-2 Console Port Baud Rate
If DIP switch 3 is on (down), these two switches set the
baud rate for the console port on the back of the unit. Note
that these switches control the external CONSOLE port
only. If DIP switch 3 is off (up), switch 1 and 2 have no
effect. See Figure 6 below.
1
2
1
2
9600 19200
1
2
1
2
38400 57600
Figure 6. Console Port Baud Rate Settings
3 Force Console Port to Rate Set by DIP Switches 1 and 2
Since software can change the baud rate of the external
serial port, it is possible to forget what speed it is using.
This switch allows you to force the console port to a known
rate designated by switches 1 and 2.
OFF Use software configured rate
ON Force DIP switch rate