User manual

9-20 Administrative Tool
s
1
2
3
4
ON
OFF
Figure 3. I-modem DIP Switches (factory defaults)
Switch Function
1 Power-on/Reset Load Configuration Defaults
OFF Load from nonvolatile memory (NVRAM)
ON Load factory settings from ROM
2 AT Command Set Recognition
OFF Command recognition disabled (Dumb mode).
Not a valid setting when the I-modems are used
with NETServer.
ON Enabledcommand set recognized (Smart mode)
3-4 Reserved
These switches are reserved for use by U.S. Robotics.
Please do not change their settings.
NETServer CONFIGURATION DIP switches
The NETServer CONFIGURATION DIP switches control the
NETServer hardware (see Figure 4). Only Switch 4 is required to
be set to the ON position.
Figure 4. NETServer CONFIGURATION DIP Switches