User manual

Administrative Tools 9-1
9
Figure 1. NETServer 8 Plus I-modem Back Panel
V.34 Modem DIP Switches
DO NOT change default settings for a software download.
Figure 2 shows a row of V.34 modem DIP switches in their
factory settings. The defaults reflect typical system
requirements such as: Result Codes displayed, AT commands
enabled and Remain Connected on Escaped Code. If you think
the factory settings need to be changed, see the table in Appendix
C: LEDs and DIP Switches.
Figure 2. V.34 Modem DIP Switch Functions (factory defaults)
I-modem DIP Switches
DO NOT change the 4 I-modem DIP Switches for a software
download.
Note: If a modem download is unsuccessful and corrupts your
RAM, set DIP Switch 1 to the ON position to load factory
settings from ROM. Be aware that after returning to the factory
defaults, all modems must be reprogrammed to reflect your
desired settings. After you have reset and saved your modem
configuration, set Switch 1 to the OFF position and reboot. See
Figure 3 on page 9-21.