User manual

9-18 Administrative Tool

S32=009 S33=000 S34=000 S35=000 S36=000 S37=000 S38=000 S39=000

S40=000 S41=000 S42=126 S43=200 S44=015 S45=000 S46=255 S47=000

S48=000 S49=016 S50=100 S51=064 S52=005 S53=064 S54=064 S55=000

S56=000 S57=000 S58=000 S59=000 S60=000 S61=000 S62=000 S63=000

S64=000 S65=000 S66=000 S67=016 S68=000 S69=000

LAST DIALED #:

To use other AT commands, consult the AT manual supplied in

your package.

Performing a Software Download

This section describes how to download a new FLASH file

image (.NAC) to the FLASH file system via the CLI. The

process is automated. All you have to do is make sure your

cabling is connected, set the DIP switches, load the diskette with

all PCSDL files and type the download command. The only

requirement is that your console connection be attached locally -

the PCSDL program does not support a network download -

your connection must be hardwired via the console port.

Note: We recommend you use the Windows-based NETServer

Manager Plus to download a new NAC. image. This program

can download the software remotely.

DIP Switches

There are two rows of DIP switches on the NETServer/8. The

MODEM CONFIGURATION (unnamed for I-modems) DIPs

control I-modem or V.34 modems. On both NETServer/16

models, there are three sets of DIP switches and each of the top

two rows controls four of the I-modems or eight of the V.34

modems. See NETServer/8 I-modem back panel graphic on

page 9-20.