User manual

9-4 Administrative Tool
s
Setting
Code
Switch protocol
W
Multipoint
M
Dialing Mode
O
SPID (odd-numbered interface)
S1
SPID (even-numbered interface)
S2
Directory No. (odd-numbered interface)
P1
Directory No. (even-numbered interface)
P2
TEI (odd-numbered interface)
T1
TEI (even-numbered interface)
T2
Call Type (odd-numbered interface)
V1
Call Type (even-numbered interface)
V2
Setting
Options
M=0
Point-to-Point
M=1
Multipoint
O=0
En-Bloc mode
O=1
Overlap Sending mode
T1 (or 2)=0
Automatic TEI
T1 (or 2)=1-63
Manual TEI settings
V1 (or 2) =0
Autodetect
V1 (or 2) =1
V.120 rate adaption only
V1 (or 2) =2
V.110 reate adaption only
V1 (or 2) =3
Modem or fax only
V1 (or 2) =4
Clear-channel synchronous
V1 (or 2) =5
Internet (asynchronous to synchronous PPP
W=0
AT&T 5ESS Custom
W=1
Northern Telecom DMS-100
W=2
National ISDN-1
W=3
Euro-ISDN
Reminder: When you change any I-modem parameter, remember
to issue an ATZ! command immediately afterwards to reset the
modem. For example:
set imodem interface mod:4 at_command atz!
For more information on this command, see the CLI Reference
Guide.