User manual

Packet Filters 8-1

Deleting a Packet Filter

To delete a specific packet filter, removing the filter file

permanently from the NETServer flash memory, use the

following command:

delete filter

<filter_name>

Verifying Filter File Syntax

The verify filter command is useful if you make changes to a

filter file that has already been added to the managed list and

re-TFTP the file back into the NETServer flash memory (using

the same filename).

The verify filter file will check the filter syntax. If the syntax is

valid, no message is generated and the command prompt

returns. If the syntax is not valid, error messages are generated

detailing the source of the errors.

To verify a filter file, use the following command:

verify filter

<filter_name>

Showing Filter File Contents

To view the contents of an entire filter file that has been added

to the managed list of filters, use the following command:

show filter

<filter_name>

To display the contents of the filter file by protocol, use the

following command:

show filter

<filter_name>

protocol

[BR-ETH | BR-ETH-CALL | IP | IP-

ATALK-CALL | ATALK-ZIP]