User manual

Packet Filters 8-1
3
9.
The NETServer does not recognize a filter file stored in its
flash memory until you add it to the managed filter table.
Use the following NETServer CLI command to add the filter
to the managed filter table:
add filter
<name
>
Note: If you’re editing a filter file already stored in FLASH, you
don’t have to use the add filter command. Be sure it has been
verified though.
When the filter is added, the NETServer automatically verifies
the filter file syntax. If the syntax is valid, no message is
generated and the command prompt returns. If the syntax is
not valid, error messages are generated detailing the source of
the errors.
Tip: You can use the list files command to ensure the filter file
was successfully stored in the NETServer FLASH memory.