User manual

LAN-to-LAN Routing 7-2

Now configure the same routing parameters for IPX:

set network user netserv_a ipx_routing all

Specify the phone number for NETServer A:

set user netserv_a phone_number 5085552222

Configuring Connection Parameters

Connection parameters determine how the LAN-to-LAN

connection is handled by the NETServer. Follow these steps:

Configure the user as an on-demand user type:

set dial_out user netserv_a site type ondemand

Set the idle timeout to 30 minutes (1800 seconds). This

value determines how long the on-demand connection

remains up if no packets are being sent or received:

set user netserv_a idle_timeout 1800

Setting PAP Authentication

In this example, we will use PAP authentication on both sides of

the link. Follow these steps to enable PAP authentication on

NETServer B:

Set the authentication name that will be transmitted to

NETServer A to "branch_office":

set system transmit_authentication_name branch_office

Set the authentication type to PAP:

set ppp receive_authentication pap