User manual

7-18 LAN-to-LAN Routin
g
LAN-to-LAN Routing Case Study
This section provides an example how to set up two NETServers
located on separate LANs to perform LAN-to-LAN routing over
a dial-up PPP link.
The diagram below depicts two LANs connected by two
NETServers: NETServer A and NETServer B. This
configuration will enable IP, AppleTalk, and IPX protocols to be
routed across a standard PPP link.
Note: Many of the commands and keywords shown in this case
study are abbreviated. For detailed information about
command syntax, refer to the CLI Reference Guide.
192.112.226.1
192.112.226.2
255.255.255.0
Default Router: 192.112.226.1
MacIntosh
AppleTalk Range: 1-5
Zones: Alpha, Beta
Novell Server - PC
IPX Address: 7
Frame Type: Ethernet II
NETServer A
192.112.227.1
NETServer B
192.112.227.2
255.255.255.0
Default Router: 192.112.227.1
MacIntosh
AppleTalk Range: 10-20
Zones: azone, bzone
Novell Client - PC
IPX Address: 8
Frame Type: Ethernet II
78.0.0.2
78.0.0.1
PPP Link
Figure 2. Sample LAN-to-LAN Routing Case