User manual

7-12 LAN-to-LAN Routin

Manual (Used for debugging) The NETServer dials out

only when it receives a dial command from the

command line.

Continuous The NETServer will attempt to maintain the

connection at all times. If the connection is

broken it will dial again.

Start Time

Specifies the time to start a timed connection. The default is

00:00:00.

End Time

Specifies the time to end a timed connection. The default is

00:00:00.

Modem Group

Specifies which pool of modems will dial out to the remote

location. The NETServer will only use ports that belong to this

group to dial out to the remote location. If you do not configure

a modem group, the NETServer will use any available port to

dial out. The default is all.

Use the following command:

set user

<name>

modem_group

Idle Time-out

Applies to Manual and On-Demand locations only. This field

specifies how many minutes a dial out connection to this

location can remain idle (no packets being sent or received)

before the NETServer disconnects. The idle timer ignores RIP,

RTMP, SAP and keepalive packets, allowing ports to time-out

even though these protocols are running. The default is 0

(disable idle time-out).

Note: You must set the Idle Time-out field to something other

than its default (no time-out) for On-Demand locations. If not,

the initial connection will stay up permanently.