User manual

LAN-to-LAN Routing 7-11
Step 4 - Set the Remote Device Phone Number
Specify the remote device's phone number using the following
command:
set user
<name>
phone_number
<number>
You can also specify an alternate phone number that the
NETServer will dial if it cannot connect using the primary
phone number. Use the following command:
set user
<name>
alternate_phone_number
<number>
Step 5 - Configure Dial-Out Parameters
Dial-out parameters determine how the NETServer will initiate
and handle the dial-out connection to the remote router. Use
the following command:
set dial_out user
<name>
site type
[on_demand | timed | manual | continuous]
start_time
<time>
end_time
<time>
modem_group
<name>
idle_timeout
<seconds>
Type
Determines when the NETServer will dial out to the remote
device. The default is manual.
On Demand The NETServer dials out to the remote device
when it has packets queued for that location. It
then maintains the connection only as long as
there is traffic on the line. Note that dynamic
routing information is updated while there is a
connection between the two devices, but not
before the NETServer dials or after it hangs up.
Timed The NETServer dials out at times of the day that
you specify. See the start time and end time
parameters for more information.