User manual

7-10 LAN-to-LAN Routin

AppleTalk

Enables or disables AppleTalk. The default is enable.

Step 3 - Specify a Remote Address

Unlike a remote end user connection, you must specify a remote

address for the type of LAN-to-LAN connection you are

configuring.

You can use an un-numbered interface or a numbered interface:

• un-numbered interface - uses the address of the unit itself.

The advantage is that you save addresses

• numbered interface - uses the address of a specific port on

the remote device

Remote IP Address

To specify an remote IP address:

set network user

<name>

address_selection specified

remote_ip_address

<ip_address>

Remote IPX Address

To specify a remote IPX address:

set network user

<name>

ipx_address

<ipx_address>

Note: If the IPX address specified in the profile is in use

when the user dials in, the call will be dropped.

Remote AppleTalk Range

To specify a remote AppleTalk range:

set network user

<name>

range_appletalk

<range>

MTU

The Maximum Transmission Unit specifies the size of the largest

packet that may be sent to this location. The default is 1514.