User manual

LAN-to-LAN Routing 7-
9
Password
Unique user password.
Type
A LAN-to-LAN user is always a dialout and network user type,
since the NETServer will be dialing out to the remote router and
performing framed network services.
Tip: At this point, it may be helpful to use the show user
command to display the user's default parameters. This allows
you to decide which parameters you need to set, and which
parameters you can leave as defaults.
Step 2 - Configure Network Parameters
Configure the network parameters you'll need to perform
LAN-to-LAN routing using the following command:
set network user
<name>
network_service
[PPP | SLIP]
ip
[enable | disable]
ipx
[enable | disable]
appletalk
[enable | disable]
address_selection specify
remote_ip_address
<ip_address>
remote_ipx_address
<ipx_address>
range_appletalk
<range>
mtu
<number>
Network Service
IP, IPX, and AppleTalk connections use PPP. IP connections can
also use SLIP. The default is PPP.
IP
Enables or disables IP. The default is enable.
IPX
Enables or disables IPX. The default is enable.