User manual

Network Dial-Out Access 6-1
5
5.
To test your setup, load the Windows Terminal program
found in the Accessories group. Set the communications
port to the re-directed COM Port and click on Ok. You
should now see a blinking box.
Type at&f, press , and you should get an OK response.
This response means that NCSIPort is configured correctly
and ready to be used.
Click on Phone, then click on H
angup to disconnect. Then,
click on File and click on Exit to end this test.
Using NPC’s Client for Windows 3.x
Once NCSIPort. has been setup and saved into your Windows
Startup group, you can begin using IPX Dial-out by setting up a
NCSI-compatible communications program such as ProComm
Plus or non-NCSI compatible HyperTerminal to use the
specified NCSI-redirected COM Port and modem settings.
After you have configured your communications software,
simply use it as you normally would.
NPC Client Installation for Windows 95
To install the NPC Client software for Windows 95:
1.
Start Windows 95, click on the Start button on the Windows
Taskbar, then click Run.
2.
Insert the Windows 95 Client Installation diskette into the
floppy disk drive. At the Run command line, type:
a:\setup.exe
3.
In the
Welcome
screen, click
I
nstall
. If you are installing
the NPC client on an:
• IPX network, click
Yes
at the Install NCSI for Novell based
Networks prompt.
• IP network, click
No
at the Install NCSI for Novell based
Networks prompt and then click
Yes
at the Install NCSI
for IP based Networks prompt.
Accept the default directory (c:\ncsi95) or enter a directory
name. The software will then be installed on your system.