User manual

6-8 Network Dial-Out Acces
s
PC Client Software Installation and Setup
The NPC Client Setup program is designed to run on any LAN
workstation using the Novell IPX protocol connected to a
NETServer. See the appropriate section listed on the following
pages for procedures to set up on various platforms.
WARNING: Before installing or running NPC Client programs,
make sure that Novell’s VLM environment is loaded
beforehand. Issuing the NCSI command in a non-VLM
environment may cause your system to lock-up.
NPC Client Installation for DOS
To install the Client software for DOS:
1.
Make a sub-directory on your PC’s root directory by typing:
md ncsi
2.
Change to the newly created sub-directory by typing:
cd ncsi
3.
At the c:\ncsi\> prompt, place the DOS Client disk
provided into your floppy disk drive (for this exercise,
assume disk drive A) and issue the following command to
install the necessary files:
xcopy a: *.* /s/e
.
After installing the Client software, execute the commands
needed to configure and use the DOS Client program.
Using NPC’s DOS Client
There are two ways you can use NPC’s DOS Client software.
• Use the NTERM
2
terminal emulator software
• Issue commands through the command line interface using
the BTTY command line terminal emulator